How to install the back box of the motorcycle

The abnormal noise is actually caused by a gap, it is recommended to find something thinner like a sponge, plug it when closing the tail box, so that it can play a role in enrichment and buffering.
Motorcycle all kinds of strange noise, abnormal noise diagnosis detection and repair
(1) The solution to the abnormal sound of disc brakes
Reason: If your motorcycle clangs the brake pads when it crosses a pothole or vibrates, it must be a problem with the disc brakes.
Workaround:
1. Prepare a hat that unscrews the screw and a 6-corner lever in No. 5.
2. Then use the No. 5 inner 6 corner wrench to loosen the brake pad to fix the screw, and then unscrew the caliper fixing screw.
3. Remove the brake pad to see the limit shrapnel of the brake pad, this shrapnel is embedded in the calipers, pay attention to see that there is a buckle on the side, pull it out by hand or use flat cocking.
4. Take out the shrapnel and use sharp-nosed pliers to tilt the arc of the shrapnel up slightly.
5. The arc can be cocked to a larger point, so that the brake pads will not sound if it is too large or vibrating too much
6. Then observe the fixed screw under the brake pad, the hand touch is smooth, generally long-term brake, the screw is always a little astringent.
7. Fine sandpaper is slightly polished and smooth, coated with butter, and then put in the brake pads, because the arch is so large that you have to press the brake pads by hand.
8. Then insert the fixed screw of the brake pad. Put it back as it is. Finally, tighten the fixing screw with glue butter.
9. After installation, pinch and loosen the brake until it returns to position.